Consider the assertions/ characteristics given below. Which type of attenuation measurement technique exhibits these characteristics?

1. Necessity of accessing both ends of fiber.
2. Measurements corresponding to specific wavelengths.
3. Requirement of spectral response over a range of wavelengths.

In an optical fiber communication system, which among the following is not a typical transmitter function?

A. Coding for error protection

B. Decoding of input data

C. Electrical to optical conversion

D. Recoding to match output standard

Which among the following is provided by an optical receiver for the regeneration of data signal with minimum error?

A. Photo-diode

B. Signal Processing Circuits

C. Linear Circuitry

D. None of the above

For a sine wave, the frequency is represented by the cycles per ______

A. Second

B. Minute

C. Hour

D. None of the above

Which property/ies of PCM stream determine/s the fidelity to original analog signal?

A. Sampling rate

B. Bit depth

C. Both a and b

D. None of the above

In single-mode fibers, how does the fraction of energy traveling through bound mode appear in the cladding?

A. As a crescent wave

B. As a gibbous wave

C. As an evanescent wave

D. All of the above